bpf: Fix skb_pull() BUG in __bpf_redirect_neigh()

Summary

CVECVE-2026-99751
StatePUBLISHED
AssignerLinux
Source PriorityCVE Program / NVD first with legacy fallback
Published2026-11-20 06:18:13 UTC
Updated2026-11-20 06:18:13 UTC
DescriptionIn the Linux kernel, the following vulnerability has been resolved: bpf: Fix skb_pull() BUG in __bpf_redirect_neigh() The issue: This is a follow-up to the short link-layer header fixes from Eric. After vlan pop_eth, a privileged SCHED_ACT BPF program can call bpf_skb_change_head(skb, 1, 0) and then bpf_redirect_neigh(). __bpf_redirect_neigh() calls skb_pull(skb, sizeof(*ethh)) after checking only that mac_header < network_header. Nothing verifies that the MAC header is long enough, that it is linear, or that the IP header the redirect goes on to read is linear either. A SCHED_ACT BPF program can do: bpf_skb_change_head(skb, 1, 0); bpf_redirect_neigh(lo, NULL, 0, 0); after vlan pop_eth. The skb then has mac_len == 1 and only one byte of linear data; skb_pull(ETH_HLEN) trips the skb->len < skb->data_len BUG in __skb_pull(): kernel BUG at ./include/linux/skbuff.h:2839! RIP: skb_pull+0x40/0x50 Call Trace: skb_do_redirect -> packet_xmit -> packet_sendmsg Kernel panic - not syncing: Fatal exception in interrupt The v4 and v6 paths read ip_hdr() and ipv6_hdr() as soon as the MAC header is gone. On the AF_PACKET frame below that leaves headlen == 0 after the pull, so the network header sits at skb->tail and the route lookup reads ip4h->protocol, ip4h->saddr and ip4h->daddr past the linear area. The Fix: Use skb_network_offset(), which is the MAC header span, instead of skb->mac_len. mac_len is zero for locally generated tc egress and netkit packets, while the span still rejects the one-byte header produced by pop_eth + bpf_skb_change_head(skb, 1, 0). The single check also covers the mac_header >= network_header test it replaces. Use pskb_may_pull() to make the Ethernet header linear before it is read or pulled, and to make the IP header linear in both the v4 and the v6 path before ip_hdr()/ipv6_hdr() is read. The header pointers are taken after the pull, since pskb_may_pull() may reallocate skb->head. Conditions to recreate the bug: On x86-64 with 4 KiB pages, enable CONFIG_PACKET, CONFIG_BPF_SYSCALL, CONFIG_NET_SCH_INGRESS, CONFIG_NET_CLS_MATCHALL, CONFIG_NET_ACT_VLAN and CONFIG_NET_ACT_BPF. Run as root with BPF loading, network administration and raw-packet privileges. Bring lo up and attach a SCHED_ACT program that calls bpf_skb_change_head(skb, 1, 0), then returns bpf_redirect_neigh(skb->ifindex, NULL, 0, 0): ip link set lo up tc qdisc add dev lo clsact tc filter add dev lo egress matchall action vlan pop_eth pipe \ action bpf object-file neigh_chghead.o section action Send an untagged ETH_P_IP frame of ETH_HLEN + 8192 bytes through an AF_PACKET/SOCK_RAW socket bound to lo, without PACKET_VNET_HDR or PACKET_QDISC_BYPASS. Use a unicast destination MAC. The sender's skb has a 14-byte linear Ethernet prefix and a fragmented payload; pop_eth removes that prefix and change_head restores only one linear byte. The unfixed neighbor redirect then tries to pull 14 bytes and BUGs. Sending the same frame without pop_eth and change_head leaves the IP header in the frags, which is the route lookup reading past skb->tail.

Vendor Declared Affected Products

SourceVendorProductVersionPlatforms
CNA Linux Linux affected b4ab31414970a7a03a5d55d75083f2c101a30592 a725401dd629c6fdda47e3a02efed539ac0ed6d0 git Not specified
CNA Linux Linux affected b4ab31414970a7a03a5d55d75083f2c101a30592 2009032471be8b9622bf2496ce9c6b06a1015905 git Not specified
CNA Linux Linux affected b4ab31414970a7a03a5d55d75083f2c101a30592 890fd9c4e02bc9e477e6365fef4ac8c2262a3b3c git Not specified
CNA Linux Linux affected b4ab31414970a7a03a5d55d75083f2c101a30592 23503acb214cbefaf3945d05ab9667ff11ae3de9 git Not specified
CNA Linux Linux affected 5.10 Not specified
CNA Linux Linux unaffected 5.10 semver Not specified
CNA Linux Linux unaffected 6.12.118 6.12.* semver Not specified
CNA Linux Linux unaffected 6.18.64 6.18.* semver Not specified
CNA Linux Linux unaffected 7.3.5 7.3.* semver Not specified
CNA Linux Linux unaffected 7.4-rc2 * original_commit_for_fix Not specified

References

ReferenceSourceLinkTags
git.kernel.org/stable/c/a725401dd629c6fdda47e3a02efed539ac0ed6d0 416baaa9-dc9f-4396-8d5f-8c081fb06d67 git.kernel.org
git.kernel.org/stable/c/2009032471be8b9622bf2496ce9c6b06a1015905 416baaa9-dc9f-4396-8d5f-8c081fb06d67 git.kernel.org
git.kernel.org/stable/c/23503acb214cbefaf3945d05ab9667ff11ae3de9 416baaa9-dc9f-4396-8d5f-8c081fb06d67 git.kernel.org
git.kernel.org/stable/c/890fd9c4e02bc9e477e6365fef4ac8c2262a3b3c 416baaa9-dc9f-4396-8d5f-8c081fb06d67 git.kernel.org
CVE Program record CVE.ORG www.cve.org canonical
NVD vulnerability detail NVD nvd.nist.gov canonical, analysis

© CVE.report 2026

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.

CVE, CWE, and OVAL are registred trademarks of The MITRE Corporation and the authoritative source of CVE content is MITRE's CVE web site. This site includes MITRE data granted under the following license.

Free CVE JSON API cve.report/api

CVE.report and Source URL Uptime Status status.cve.report